⌖WEAPONTESTER
Internal Ballistics · Builder

Barrel Length and Muzzle Velocity

Published: · 7 min read

What barrel length controls: the distance and time over which expanding propellant gas can push on the bullet before it exits. Powder burn rate matters, but “more barrel burns more powder” is incomplete: much of the charge may already have burned while pressure continues to accelerate the bullet. The net gain depends on the pressure curve, bore friction and the load. Length does not guarantee a fixed number of fps.

.308 barrel length fps chart: a measured 168 gr load

Rifleshooter's barrel-cut test fired Federal Gold Medal 168 gr BTHP from one .308 barrel, shortening it between five-round chronograph strings. The published 16.5" point is shown as 16.5", not rounded into a nonexistent 16" measurement. These are observed averages for that rifle and ammunition, not universal factory velocities.

Federal Gold Medal 168 gr BTHP · measured muzzle velocity
BarrelAverage MVChange vs 24"
16.5"2,466 fps-169 fps
18"2,523 fps-112 fps
20"2,565 fps-70 fps
22"2,597 fps-38 fps
24"2,635 fps0 fps
26"2,673 fps38 fps

Source: Rifleshooter, .308 Winchester barrel length versus velocity. 16.5–24" measured difference: 169 fps across 7.5", or about 23 fps/in on average.

6.5 Creedmoor 140 gr ELD Match: source versus estimate

Hornady's 2021 catalog published 826 m/s (about 2,710 fps) for its 140 gr ELD Match from a 24" test barrel; later lots and catalogs can differ. In a separate Rifleshooter test, a 22" Bartlein produced 2,659 fps with that factory load; its different barrel and ammunition lot mean the two results cannot be treated as a controlled two-inch cut test. The rows below use WeaponTester's 22 fps/in planning model anchored to that historical Hornady 24" figure. Only the 24" entry is a manufacturer specification; other rows are estimates, not published measurements of this load.

Hornady Match 140 gr ELD-M · published 24" MV and modeled lengths
BarrelMVBasis
16"2,534 fpsBuilder estimate
18"2,578 fpsBuilder estimate
20"2,622 fpsBuilder estimate
22"2,666 fpsBuilder estimate
24"2,710 fpsHornady published
26"2,754 fpsBuilder estimate

Sources: Hornady 2021 catalog; Rifleshooter 22"/26" comparison. For another controlled 6.5 Creedmoor cut test, Hodgdon's 2024 manual reports a 25 fps/in average over 24–16", but its tested load is not identified here as this 140 gr ELD-M factory load.

How much fps per inch of barrel?

For planning between common rifle lengths, use roughly 20–30 fps/in for .308 Win and 15–25 fps/in for 6.5 Creedmoor. The measured .308 series above averages about 23 fps/in from 16.5" to 24"; Hodgdon's separate 6.5 test averaged 25 fps/in, and other loads differ. Individual one-inch steps can be much smaller or larger. A 16" vs 20" .308 estimate is therefore a range, not a promised 80–120 fps loss; likewise a 24" vs 26" 6.5 Creedmoor estimate is about 30–50 fps. Chronograph your actual combination for a final firing solution.

Does barrel length affect bullet drop at 1,000 yards?

Yes. A lower starting MV gives gravity more flight time. This 16" versus 24" comparison uses the builder's estimated barrel adjustment (25 fps/in .308; 22 fps/in 6.5 CM) on the catalog's published 24" MVs. Drop is computed with the site's trajectory engine, not taken from a chronograph. Conditions: 100 yd zero, 1.75" sight height, 59 °F, 29.92 inHg, sea level, no wind; .308 168 gr SMK G7 BC 0.224 and 6.5 140 gr ELD-M G7 BC 0.326. Both lengths keep the same load and zero for comparison.

Modeled 1,000 yd drop from barrel-adjusted starting velocities
LoadBarrelStart MVDrop
.308 Win · Federal Gold Medal 168 gr SMK16"2,450 fps536 in
.308 Win · Federal Gold Medal 168 gr SMK24"2,650 fps441 in
6.5 Creedmoor · Hornady Match 140 gr ELD-M16"2,534 fps371 in
6.5 Creedmoor · Hornady Match 140 gr ELD-M24"2,710 fps317 in

Modeled drop magnitudes below the line of sight, rounded to the nearest inch. Actual hold depends on your measured MV, zero, atmosphere and projectile BC.

The trade beyond velocity

A shorter barrel also changes muzzle behavior. Higher gas pressure at exit can make blast and flash more conspicuous, especially with a load and powder selected for a longer test barrel. Visible unburned powder can increase, but it is not the whole explanation for the velocity change. If fitting a suppressor, check the maker's minimum barrel rating, caliber and mounting requirements; a shorter barrel plus suppressor may still be easier to handle than a bare 26" rifle.

For a carried hunting rifle, less barrel length and weight may matter more than a modest MV gain. For PRS and other long-range target work, 24–26" is a common way to gain velocity and reduce corrections, accepting more weight and overall length. A 16–18" suppressor host favors compact handling, with a larger velocity and blast trade. Barrel quality, stiffness and ammunition still govern mechanical group size; extra length is not an accuracy guarantee.

From the barrel selector to the range

The WeaponTester builder shows each barrel's length. When a build and load are carried into /range, its MV input is adjusted from the load's test-barrel velocity to the selected barrel length. That is a caliber-level estimate, clearly labeled in the tool, not a measurement of your rifle. If you have chronograph data, use it to refine the solution.

Frequently asked questions

How much velocity does a shorter barrel lose?

Between typical rifle barrel lengths, a planning estimate is about 20–30 fps per inch for .308 Win and 15–25 fps per inch for 6.5 Creedmoor. The exact change depends on the load, barrel and conditions. Chronograph the actual rifle before using a long-range firing solution.

What is the best barrel length for 6.5 Creedmoor long range?

A 24–26 inch barrel is a common PRS and long-range choice when velocity and sighting corrections matter more than overall length. A shorter 16–18 inch barrel can make more sense for a compact suppressor host. Neither length is universally best.

Does a longer barrel make a rifle more accurate?

Length alone does not determine group size. Barrel quality, chamber, ammunition, stiffness and the rifle system matter. Extra muzzle velocity can reduce flight time and wind and drop corrections at distance, even if mechanical precision is unchanged.

Test the handling and trajectory trade with a load and barrel you can actually select.

Compare barrel lengths in the builder →

Range essentials · Amazon affiliate links

Plan beyond the simulation

Compare personal protection and note-taking supplies for your next range visit.

Hearing protection

Compare earmuffs and earplugs by fit, comfort, and the manufacturer’s published protection rating.

Compare hearing protection on Amazon →

Eye protection

Compare safety glasses by coverage, lens tint, and documented impact rating.

Compare safety glasses on Amazon →

Keep your observations together

A weather-resistant notebook gives your session notes and conditions a home away from the screen.

Browse field notebooks on Amazon →

As an Amazon Associate, we earn from qualifying purchases. Links open Amazon search results; compare the current listings and specifications there. Affiliate disclosure