Print your come-ups.
Pick a load, enter your zero, chronographed velocity and the air you shoot in. You get an elevation and wind card from 100 to 1000 yd in MIL or MOA, with turret clicks when your scope is known. Print it for the stock, save it as a PNG, or copy a link that rebuilds the same card. With the default Hornady Match 140gr ELD-M, that is +3.9 MIL at 600 yd and +8.8 MIL at 1000.
- MV
- 2710 fps
- BC
- G7 0.326
- Zero
- 100 yd · SH 1.75″
- Twist
- 1:8″ RH
- Air
- 59°F · 29.92 inHg
- RH / Alt
- 50% · 0 ft
- DA
- 110 ft
- Wind col
- 10 mph full
| Yds | Elev MIL | Wind | Spin | Fps |
|---|---|---|---|---|
| 100 | 0.0 | 0.1 | 0.0 | 2570 |
| 150 | +0.2 | 0.2 | 0.0 | 2502 |
| 200 | +0.5 | 0.3 | 0.0 | 2434 |
| 250 | +0.8 | 0.4 | 0.0 | 2368 |
| 300 | +1.2 | 0.5 | 0.0 | 2302 |
| 350 | +1.6 | 0.5 | 0.1 | 2238 |
| 400 | +2.0 | 0.6 | 0.1 | 2175 |
| 450 | +2.4 | 0.7 | 0.1 | 2113 |
| 500 | +2.9 | 0.8 | 0.1 | 2052 |
| 550 | +3.4 | 0.9 | 0.1 | 1992 |
| 600 | +3.9 | 1.0 | 0.1 | 1932 |
| 650 | +4.4 | 1.1 | 0.1 | 1874 |
| 700 | +4.9 | 1.2 | 0.1 | 1817 |
| 750 | +5.5 | 1.3 | 0.1 | 1760 |
| 800 | +6.1 | 1.4 | 0.1 | 1704 |
| 850 | +6.7 | 1.5 | 0.2 | 1649 |
| 900 | +7.4 | 1.6 | 0.2 | 1595 |
| 950 | +8.1 | 1.8 | 0.2 | 1541 |
| 1000 | +8.8 | 1.9 | 0.2 | 1488 |
Make the card match your rifle
- Zero and sight height. Measure from the bore centerline to the scope centerline. A wrong sight height mostly shows up inside 300 yd.
- Chronograph. Enter your real average MV. It moves the long-range numbers more than anything else on the card.
- Station pressure and temperature. Use what a Kestrel or phone barometer reads where you stand, not the weather report. How each one moves the bullet.
- True it. Shoot at 600 yd and beyond. If you need more elevation than the card says, lower the MV until it matches, then print again.
Reading the columns
- Elev
- Dial up this much from your zero. Negative means dial down.
- Clicks
- Elevation in turret clicks. Shown when the card unit matches your scope's turrets.
- Wind
- Hold for a full-value crosswind at the speed shown. Scale it linearly for other speeds.
- Spin
- Spin drift from a right-hand twist. The bullet goes right, so hold left.
- Fps
- Retained velocity. Ranges marked † are below Mach 1.2, where groups start to open.
Not sure which unit to print? MOA vs MIL. Choosing a zero? 100 vs 200 yd.
Questions
What goes on a dope card?
Range, the elevation to dial at each range, and a wind hold for a reference wind speed. This card adds turret clicks when your scope is known, spin drift, retained velocity, drop in inches and time of flight, plus the conditions it was computed for, so you can tell when the card no longer matches the air.
Why does the card ask for station pressure instead of altitude?
Drag depends on air density, which comes from the pressure and temperature where you stand. A Kestrel or phone barometer reads station pressure directly. Weather reports give the altimeter setting, which is corrected to sea level and would make a high-altitude card wrong. For Hornady Match 140gr ELD-M, going from ICAO sea level to 95 °F and 25.2 inHg (about 4,500 ft) cuts the 1000 yd come-up from 8.8 to 7.9 MIL.
How much does muzzle velocity matter?
A lot past 600 yd. Factory velocities come from long test barrels; a 20–24 in barrel often runs 50–100 fps slower. On Hornady Match 140gr ELD-M, 75 fps less moves the 1000 yd come-up from 8.8 to 9.4 MIL. Chronograph your rifle and enter that number.
Is the wind column for any wind direction?
It is a full-value crosswind (from 3 or 9 o’clock) at the speed you set. Hold into the wind. For a quartering wind (from 1–2 or 10–11 o’clock) use about half the value; a head or tail wind barely moves the bullet sideways.
How accurate is the card?
The numbers come from a modified point-mass solver with G7/G1 drag tables, using the ammo maker’s published MV and BC unless you enter your own velocity. It is a starting point. Shoot at two or three known distances, compare your real come-ups, and adjust MV (and then BC) until the card matches your rifle.
Start from a factory load
Each link opens the card on that load. The drop chart next to it has the full reference table at ICAO sea level.