Spin drift explained
Last updated: · 5 min read
Spin drift is a small sideways displacement caused by a spinning bullet as gravity bends its flight path. For a right-hand twist it develops to the right, even in calm air. At 500 yards it is usually an inches-scale correction; at 1000 yards it can move a group on paper or steel by roughly the width of a small scoring ring.
Why the bullet moves sideways
Rifling stabilizes the bullet gyroscopically. As gravity curves the trajectory downward, the bullet's axis does not follow that curve perfectly. Its slight yaw of repose creates a lateral aerodynamic force. The drift follows the direction of barrel twist: right for right-hand twist, left for left-hand twist. It is separate from crosswind drift and from Coriolis deflection caused by Earth's rotation.
The Litz approximation in the range
The trajectory engine adds a horizontal correction at each sampled distance using Bryan Litz's empirical approximation: SD (in) ≈ 1.25 × (Sg + 1.2) × TOF^1.83. Here TOF is time of flight in seconds and Sg is the Miller gyroscopic stability factor. The engine estimates Sg from bullet mass, diameter and length, barrel twist, temperature and station pressure. It uses a 1:10-inch right-hand twist when no twist is supplied. Its spin-drift term omits the small Miller muzzle-velocity correction; it is therefore an approximation, not a six-degree-of-freedom calculation. For more on Sg and twist, see thebarrel twist and stability guide.
What scale at 500 and 1000 yards?
The catalog includes Federal Gold Medal Match .308 Win 168 gr SMK at 2650 fps and Hornady Match 6.5 Creedmoor 140 gr ELD-M at 2710 fps. The figures below are published Litz reference scale, not engine output or load-specific predictions. Litz's worked .308 example gives about 1.6–2.4 inches at 500 yards for two twist rates; Applied Ballistics describes 8–9 inches as typical at 1000 yards across small-arms trajectories, with 10–12 inches as an upper guide. Applying that broad scale to either catalog match load is an inference, so it should not be used as a dope card. Actual drift depends on each barrel's twist, measured velocity, bullet length, time of flight and atmosphere.
| Catalog example | 500 yd | 1000 yd |
|---|---|---|
| .308 Win · 168 gr SMK | about 2 in | typically 8–9 in |
| 6.5 CM · 140 gr ELD-M | about 2 in | typically 8–9 in |
The 500-yard benchmark comes from Litz's .308 175 gr SMK example at 2800 fps, not either load above. The 1000-yard benchmark covers small-arms trajectories generally. Neither figure isolates a catalog load under a validated reference condition.
Keep the corrections separate
The range's windage readout combines crosswind and spin drift. In a calm simulation, the remaining lateral offset is the model's right-hand spin correction. When comparing .308 Win and 6.5 Creedmoor at distance, keep this effect separate from the larger wind difference; see the cartridge comparison. A recorded zero and observed impacts on paper or steel are the final check for a particular rifle and load.
Frequently asked questions
Does spin drift need wind?
No. It develops in calm air. A crosswind can add to or oppose it.
How much is typical at 1000 yards?
Applied Ballistics gives 8–9 inches as a typical small-arms reference and 10–12 inches as an upper guide, not a load-specific correction.
Does left-hand twist reverse the drift?
Yes. Physical gyroscopic drift changes sides with twist direction. The current range model applies a right-hand correction.
Sources
- Bryan Litz, Applied Ballistics for Long Range Shooting, 3rd ed., chapter 6, equation 6.1 and figure 6.9. Source for the approximation and the 500-yard .308 example.
- Applied Ballistics, Gyroscopic Drift and Coriolis Effect. Source for the typical 1000-yard scale and twist direction.
- Applied Ballistics, AB Mobile User Guide, Spin Drift entry. Source for the role of bullet length and twist in a spin-drift solution.